Crossover manifold and installation

June 7, 2018

10

0

After painting the wrinkle paint, I added orange for some flare...and then cleaned off the paint on the lettering with a wizzer pad.

After painting the wrinkle paint, I added orange for some flare...and then cleaned off the paint on the lettering with a wizzer pad.

0 2018/06/07 10:24:48 19529

The beauty comes thru after buffing the lettering

The beauty comes thru after buffing the lettering

0 2018/06/07 10:25:10 19529

How they look prior to installation. I added wrinkle paint and then overpainted the color.

How they look prior to installation. I added wrinkle paint and then overpainted the color.

0 2018/06/07 10:25:40 19529

I took off the other set as one piece and you can compare them here

I took off the other set as one piece and you can compare them here

0 2018/06/07 10:25:52 19529

I glue the gaskets to the engine and add grease to the manifold side, I can remove the intake and re use the gaskets this way. I also coat the piping and rubber hoses on the inside to allow easier assembly and removal

I glue the gaskets to the engine and add grease to the manifold side, I can remove the intake and re use the gaskets this way. I also coat the piping and rubber hoses on the inside to allow easier assembly and removal

0 2018/06/07 10:26:08 19529

Installed in engine bay and ready for a road test. CAI pipes are off as I TEST TEST everything before adding the piping, saves time and helps prevent rework

Installed in engine bay and ready for a road test. CAI pipes are off as I TEST TEST everything before adding the piping, saves time and helps prevent rework

0 2018/06/07 10:27:04 19529

EYE CANDY and a bit more performance with the straighter crossover pipes

EYE CANDY and a bit more performance with the straighter crossover pipes

0 2018/06/07 10:27:17 19529

I tried several colors and chose this one as it works for ME. You can pick and choose your own

I tried several colors and chose this one as it works for ME. You can pick and choose your own

0 2018/06/07 10:27:30 19529

THis is the beginning shot of my original prototypes showing the crossover piping. Swap took me one hour start to testing on road.

THis is the beginning shot of my original prototypes showing the crossover piping. Swap took me one hour start to testing on road.

0 2018/06/07 10:27:57 19529

I like to use gasket glue to hold the motor side of gaskets and then grease the opposite side to allow disassembly. I often reuse gaskets this way, works for me over the last 50 years .

I like to use gasket glue to hold the motor side of gaskets and then grease the opposite side to allow disassembly. I often reuse gaskets this way, works for me over the last 50 years .

0 2018/06/07 11:05:04 19529