Exterior & Lighting Any questions related to exterior, lighting and styling go in here.

Can't turn off left indicator. Illuminated solid.

Thread Tools
 
  #1 (permalink)  
Old 04-25-2016 | 06:43 AM
GeorgeHirata's Avatar
Thread Starter
Joined: Dec 2015
Posts: 21
Likes: 1
From: Adelaide
Default Can't turn off left indicator. Illuminated solid.

Hi, I've been having problems with my indicators flashing randomly when I park my car. At first the siren used to make a noise, and then it became a croaking cricket like noise. I have read a few posts indicating that the problem might be due to the Alarm Control Module's battery running low.
Admittedly, I have had my car for approximately 10 years so I am not surprised if the battery has gone flat.
I then noticed that the indicators would flash, and then get stuck on being on solid and this was initially resolved by locking, unlocking, locking, unlocking the doors.
Now, it doesn't seem to respond and just the left indicator is left turned on. I decided to buy the 2 x Varta 3.6v batteries that are contained in the ACM (Alarm Control Module) as the ACM costs $480 AUD from Mercedes Benz. I have since disconnected and taken out the ACM from the car, but the left indicator light is still turned on.
Will the fixed ACM with new batteries resolve this? Or do you guys think that this might be an indicator fuse (which I don't know where it is located)?
Any help would be much appreciated.
Thanks guys.

George.
 
  #2 (permalink)  
Old 04-25-2016 | 08:13 AM
ala_xfire's Avatar
Senior Member
Joined: Dec 2010
Posts: 12,779
Likes: 162
From: Lineville, AL
Default Re: Can't turn off left indicator. Illuminated solid.

A fixed or new ACM will not fix it. It has only 3 wires running to it, +12, ground and a control wire to trigger it.
You have something screwed up in the wiring, or your ILCM ( headlight switch )
The fuses for the lights are located in the ILCM, pop the cover off the driver's side of the dash and you'll see them. ( the cover has a fuse chart )
 
  #3 (permalink)  
Old 04-25-2016 | 08:51 AM
GeorgeHirata's Avatar
Thread Starter
Joined: Dec 2015
Posts: 21
Likes: 1
From: Adelaide
Default Re: Can't turn off left indicator. Illuminated solid.

Originally Posted by ala_xfire
A fixed or new ACM will not fix it. It has only 3 wires running to it, +12, ground and a control wire to trigger it.
You have something screwed up in the wiring, or your ILCM ( headlight switch )
The fuses for the lights are located in the ILCM, pop the cover off the driver's side of the dash and you'll see them. ( the cover has a fuse chart )
Thank you kindly.
Is the ILCM the one next to the dash when you open the door with the two flat head plastic screws holding the cover in?
 

Last edited by GeorgeHirata; 04-25-2016 at 08:54 AM.
  #4 (permalink)  
Old 04-25-2016 | 09:03 AM
ala_xfire's Avatar
Senior Member
Joined: Dec 2010
Posts: 12,779
Likes: 162
From: Lineville, AL
Default Re: Can't turn off left indicator. Illuminated solid.

Originally Posted by GeorgeHirata
Thank you kindly.
Is the ILCM the one next to the dash when you open the door with the two flat head plastic screws holding the cover in?
Yes, that's it.
 
  #5 (permalink)  
Old 04-25-2016 | 10:21 AM
GeorgeHirata's Avatar
Thread Starter
Joined: Dec 2015
Posts: 21
Likes: 1
From: Adelaide
Default Re: Can't turn off left indicator. Illuminated solid.

Originally Posted by ala_xfire
Yes, that's it.
Thank you once again. I'll go check it out. See how it goes!
 
  #6 (permalink)  
Old 04-25-2016 | 10:22 AM
ala_xfire's Avatar
Senior Member
Joined: Dec 2010
Posts: 12,779
Likes: 162
From: Lineville, AL
Default Re: Can't turn off left indicator. Illuminated solid.

Good on ya, mate !
 
  #7 (permalink)  
Old 04-26-2016 | 04:50 AM
GeorgeHirata's Avatar
Thread Starter
Joined: Dec 2015
Posts: 21
Likes: 1
From: Adelaide
Default Re: Can't turn off left indicator. Illuminated solid.

Hello Ala_Xfire,
Thank you for your assistance. Here is what I did:
*Removed Alarm Control Module
*Replaced Indicator light bulb.
*Replaced the fuse in the ILCM
Since doing the above, the indicator light has resumed normal functionality. WINNING!!!


I have also dropped off the ACM and new batteries to the local electrician to fix up before re-installing it back into the car. Hence, no randomly flashing indicator lights in the meantime. WINNING AGAIN!!!


I felt like I was a mechanic and felt very masculine for it. LOL.


Thank you for all your help, you're a god-send.
 
  #8 (permalink)  
Old 04-26-2016 | 08:46 AM
ala_xfire's Avatar
Senior Member
Joined: Dec 2010
Posts: 12,779
Likes: 162
From: Lineville, AL
Default Re: Can't turn off left indicator. Illuminated solid.

GREAT !!!! Hope your electrician does not find that the old batteries ruptured and corroded the circuit board, which often happens.
Print out the .pdf I did on this and take it to him.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
onehundred80
Audio, Video and Electronics
4
03-10-2016 10:44 AM
Mr5150
Crossfire SRT6
7
02-26-2016 10:55 PM
dpeel82
Crossfire SRT6
22
02-24-2016 01:12 PM
bbrette
TSBs and How-To Articles
9
02-18-2016 01:59 PM
nickwe21
Crossfire Coupe
19
02-16-2016 10:15 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -4. The time now is 02:41 AM.