Another BAS/ESP conundrum

Reply Subscribe

Thread Tools

#21 (permalink)

01-31-2016, 10:29 AM

onehundred80

Senior Member

Join Date: Apr 2006

Location: Ontario

Age: 84

Posts: 25,429

Likes: 65

Received 611 Likes on 511 Posts

Re: Another BAS/ESP conundrum

Quote:

Originally Posted by Sussudio

"Little push" as in I pushed it as hard as I could towards the clutch plate. It just wasn't seated properly.
I'm curious though as why would the snap ring allow the pulley to retract back to the clutch plate? If that were the case then the bolt would have slack in it no?

The bolt and washer clamp the inner bearing, there has to be some clearance between the outer bearing thickness and the snap ring. I would have guessed it to be about .003/.006" min/max. If it moved that much it could close the gap to spec.
How tight was the bearing in the pulley? If you just pushed it it could not have been too tight.
If you could push on it and get it to move I would have guessed that the magnet would have done it as it is quite strong.

Reply Like

#22 (permalink)

01-31-2016, 10:32 PM

KDW4Him

Senior Member

Join Date: Nov 2011

Location: Alma, MI

Posts: 1,284

Likes: 57

Received 27 Likes on 17 Posts

Re: Another BAS/ESP conundrum

Quote:

Originally Posted by Sussudio

I have an OBD 2 reader but no codes. I'm thinking I'll need something more professional. A friend of mine has a buddy with something that's able to read Mercedes codes, haven't been able to go over to his place yet. I'm going to try ASAP though.

Reading more posts and it seems my pulley and clutch plate seem to have a wider gap between them, more than normal for sure.

OBDII will not read OEM codes.

DRBIII at the dealer is the only way. Some have reported an Autel reader can. But without the exact cause of the code we are only guessing.

Reply Like