piggy back cranck position sensor
piggy back cranck position sensor
I am in the process of installing a piggyback on the side, to use only when spraying nitrous.
I will put few degrees back on timing for safety reasons when on nitrous.
the piggyback is communicating with the cranckposition sensor. Does any body know, how many teeth
the cranck position is reading? it it 60 teeth and 2 flats or is it 30 teeth 1 flat, and 30 teeth and one flat? without inputing the right value in the piggyback tune, it is making the car having cranking problems once in a while.
thank you.
I will put few degrees back on timing for safety reasons when on nitrous.
the piggyback is communicating with the cranckposition sensor. Does any body know, how many teeth
the cranck position is reading? it it 60 teeth and 2 flats or is it 30 teeth 1 flat, and 30 teeth and one flat? without inputing the right value in the piggyback tune, it is making the car having cranking problems once in a while.
thank you.
Thread
Thread Starter
Forum
Replies
Last Post
KDW4Him
Troubleshooting & Technical Questions & Modifications
18
09-01-2021 05:47 PM
oldvintagedude
Troubleshooting & Technical Questions & Modifications
3
08-14-2015 06:20 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)