Dyno Results
Dyno Results
I finally got the car on the dyno today and I'm happy with the results so far. 348HP and 352 ft-lbs at the wheel. I cannot wait to take the car to the low lands to see how it runs.
2012-01-25.jpg
2012-01-25.jpg
Re: Dyno Results
Originally Posted by velociabstract
I rented dyno time and Eurocharged remotely tuned my car real time on it. Sadly, I'm nowhere near your numbers. I'd be curious to see your 1/4 mile times one of these days.
Les
Les
Last edited by itsky; 01-25-2012 at 08:09 PM.
Join Date: Jan 2008
Location: North Plains, OR
Age: 74
Posts: 5,180
Likes: 0
Received 8 Likes
on
7 Posts
Re: Dyno Results
Originally Posted by ModlessG
Nice numbers where did you get the dyno done ? I would hope to be close to your hp as we have the same mods. Bandimere opens in April by the way.
Originally Posted by MAXIMUM
Sounds awesome Evan! I keep going back and forth about whether or not to do the CAI. Are there any complications with passing emissions here is Colorado with your mods?[/size]
I had the emissions test done after the CAI install and it passed with flying colors. As the emission test should not kick on the supercharger, it don't think the pulley swap would change anything. I'm not sure about the tune as I had that done after the test.
Re: Dyno Results
Originally Posted by rmaier
Evan you say the S/C would not be on during a emission test but they push the car past 1300rpm so that would engage the S/C during the testing wouldn't it?
Re: Dyno Results
Hmmmm where do you getyour emissions testing done???? They always setup the car on the rollers and it has to be in drive as the test is run because I've watched and the rear wheels spin accordingly. I see the display for the vehicle from the waiting room and the rpms as the test is administered and it goes through idle to 3600rpm several times unless you fast pass and even then it goes through the cycle at least once.