Well done.

 

I wonder if I could get T R S 6, with the letters separate and in the same font as the SRT6 badge. I'd mount them myself of course. By the way TRS6 stands for Tom's Really Sporty 6 cylinder. LOL

Seriously, if we can't do the SRT6 logo, nor the AMG logo, I'd rather they just say NeedsWings and leave it at that.

 

I like the supercharged on top.

 

I thought i would prefer them blank but i really like the Supercharged emblem - NICE!

 

I've been trying to keep up w/this thread but have been swamped with work this past week, so I may have missed a few posts.

As I recall you guys were going to do a dyno test on an SRT with the new intake (on an engine that also had the NW CAI and a crank pulley). I'm really hoping to see dyno figures before commiting to $1200 for the intake.

The flow figures were impressive, so hopefully the HP gains are equally impressive, and compelling enough for my wallet to fork out the $$$$

 

Ditto!

Les

 

I think it looks sweet! If I bring my car in for waranty work, they may think thats what they always looked like!

 

the issue with that is i think you will have a tough time attaching them. we weld the logo's on before the teflon coating. you could get a srt6 fender badge and stick ti to the top most likely, i havent tried to attach anyhtign with double sided stick tape to the teflon as the badges use though to verify

 

i scaled down the supercharged emblem a little as the one in the picture was a little too long in my opinion and just didnt look right. the supercharged emblem will be very similar to the needswings logo as far as size

 

I was just kidding, Rob.

 

I'd prefer to have mine blank in a gloss black finish, no teflon. I'd like to see some dyno #'s before I send my deposit. Thanks Rob.

 

we can have the teflon tinted black easily but to get them powdercoated black the shop we go to for that has a $250 minimum sorry

i did hear back from the teflon coater today though and no problems at all with nitrous or alcohol to the teflon coating

 

all the boxes were cut yesterday, folding them up is next

 

Please keep us updated; I'm interested in how the tape goes on. I suggest 3M.

 

ill be back on later with all the details but here ya guys go

 

O_O holly....

 

If I don't get 11's with this on I'm going to give up.

 

I think this is going to be the second most worthy mod to date! ( right after the NW CAI ) , + the INmotion tune fits in there somewhere too as you have to have enough fuel and proper timing to take full advantage of the extra air! I can't wait to get them. Good Job !!!!!

 

Did I just count 45 extra HP, or should I go back and try it again on my fingers?

If I read this wrong, then I just crapped my pants for nothing.

 

I think I have a stiffy...