Hi all,

I have a little problem with the headlight adjusting in my crossfire.

I tried to aim the headlights a little higher using the switch. They were positioned on the lowest position, so pointed a bit towards the ground.

When i switch up 1 step, the headlights come up a bit higher. On the following steps ( i believe there's like 5 orso) the headlights don't move up at all.

Anyone got an idea where to look for a problem first? or did found a other thread with the similar problem because i could find it.

All advice will be much appreciated.

Greetings D&nis

 

You would probably be a step ahead if you posted this on the UK forum, the US cars don't have this feature ( sadly )

 

That explains allot, i could find anything in the Chrysler documentation about it.
Mine's imported from Germany.
Thanks for the advice.

 

Any UK members got some clue's??

 

Really nobody??

 

There is only a couple of people in the UK who reply to some of the queries here. They tend to ignore us until they want something. Isolationism I think they call it.
Most of their questions and replies are on the UK forum.
Try to ask your question there.

 

Maybe a little late, but for the sake of an answer ...
Although there's several clicks while rotating, it has only 1 level. As also indicated on the switch, with a single '1' figure.
I've had a similar discussion during the mandatory yearly safety inspection (“APK“) and had to convince the inspector that it has only 1 level.