Crossfire 2.0 Survey
Re: Crossfire 2.0 Survey
Torpedo ,,,,hmmm.
Just so it doesn't blow up when you get where you were going.
'Cause with that power to weight, you will get there fast!
Just so it doesn't blow up when you get where you were going.
'Cause with that power to weight, you will get there fast!
Last edited by Franc Rauscher; 06-21-2013 at 11:57 PM.
Re: Crossfire 2.0 Survey
Do you have a hand in the design of that 2015 Mustang?
Re: Crossfire 2.0 Survey
Check out the similarities between the sketches and this test-mule of the new SLC:
SPYSHOTS: New SLS Replacement - Viper Killer? - MBWorld.org Forums
SPYSHOTS: New SLS Replacement - Viper Killer? - MBWorld.org Forums
Re: Crossfire 2.0 Survey
And put a usb port and aux jack in the console for music. I dont necessarily like playing my music through the cigarette lighter thing but ill take what i can get! Another thing i'd like to do if i could is shorten the wall behind the seats by about a foot. That way there would be easy access to the trunk from the cab and the seats could lean back a bit further. It kinda gets in the way to me... but just my thoughts!
Re: Crossfire 2.0 Survey
And put a usb port and aux jack in the console for music. I dont necessarily like playing my music through the cigarette lighter thing but ill take what i can get! Another thing i'd like to do if i could is shorten the wall behind the seats by about a foot. That way there would be easy access to the trunk from the cab and the seats could lean back a bit further. It kinda gets in the way to me... but just my thoughts!
shorten wall : that would also involve cutting down the gas tank : good luck !
Re: Crossfire 2.0 Survey
Thank you! I've been wanting to cut my non-functional plastic look alike vents out...will never do that, but to have something functional vs just a piece of plastic for looks is much better for me.
Thread
Thread Starter
Forum
Replies
Last Post
RED DOG
-C-I-C-C-I Discussion
25
07-26-2015 07:25 AM
MiamiTVR
Cars For Sale - Archive
4
07-14-2015 01:26 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)