Intake Manifolds & Y-Pipe
Intake Manifolds & Y-Pipe
Selling a set of OEM SRT6 Intake Manifolds and Y-pipe. Excellent condition. Also come with the rubber couplers and clamps (not pictured) for the Y-pipe. I took them off when i cleaned the parts and forgot them in the garage at picture time. Driver side manifold has an 1/8" barb fitting installed for either a boost gauge or intake temp gauge. Asking $200 obo plus shipping. No reasonable offer refused. Thanks for looking.
Re: Intake Manifolds & Y-Pipe
Selling a set of OEM SRT6 Intake Manifolds and Y-pipe. Excellent condition. Also come with the rubber couplers and clamps (not pictured) for the Y-pipe. I took them off when i cleaned the parts and forgot them in the garage at picture time. Driver side manifold has an 1/8" barb fitting installed for either a boost gauge or intake temp gauge. Asking $200 obo plus shipping. No reasonable offer refused. Thanks for looking.
Re: Intake Manifolds & Y-Pipe
Not at all. The rubber boots are more than adequately pinched against the pipe from the worm clamps holding them on. Plus they have raised lips at the edges. They'll be getting ported and polished inside only.
Re: Intake Manifolds & Y-Pipe
That is my humble opinion, you may disagree.
Re: Intake Manifolds & Y-Pipe
I was talking about the plenums, they had a finely machined surface on the bottom to clamp against a steel gasket. Looking at the way the SRT machined edges have been rounded a really coarse grit was used when glass beads, walnut shells etc would have been better to use. Whatever was used the machined surfaces should have been suitably masked.
That is my humble opinion, you may disagree.
That is my humble opinion, you may disagree.
Thread
Thread Starter
Forum
Replies
Last Post
RED DOG
Parts/Accessories for sale - Archive
2
01-30-2016 07:35 PM
jmartinpadilla
WTB - Items/Parts Wanted to Buy - Archive
7
01-08-2016 06:30 PM
jmartinpadilla
Parts/Accessories for sale - Archive
0
01-06-2016 07:22 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)